Palmetto Ez Dock - Construction - High Quality Construction

Highest Quality Construction

Extra-durable, resilient material
The extra thick deck and wall delivers maximum durability and reduces distortion. Even more thickness is built into radius areas for additional strength where impacts occur.

Virgin polyethylene with UV inhibitors is specifically formulated for outdoor use. Not harmed by gas or oil, won't rot or become brittle, & remains flexible to 130 degrees below zero. If ever damaged, sections are on-site repairable.

Color will determine the temperature of your dock!
Dark colors absorb and hold heat. Light colored objects reflect heat so they stay cooler. Not only is this important to bare feet, it protects the dock as well; an over-heated Poly-type dock can become soft, and be prone to distortion.

Versatile Modular design
The EZ Dock System is easily configured to suit most any need. Combine various size sections and accessories to create a simple swim platform or an elaborate multiple-slip marina.

Extensive choice of accessories
Customize your set-up to suit your needs perfectly. Choose from a wide variety of anchoring systems, gangway sizes, railing styles and more.

For more information on the EZ dock system visit: ez-dock.com or please call Glenn Dannelly at (803) 730-7497

Ez Dock Instalation:

Insert Coupler Bolt through bottom coupler section (square recess) and use hammer to set square head into recess of bottom coupler.
Load bottom of coupler & bolt assembly into coupler installation tool.
Slide between dock sections and align coupler bolt with hole in dock pocket (start in center of dock and position tool for removal through open pocket side of dock).
Pull bottom coupler assembly into dock pocket until hole in coupler tool is visible (you can put a screwdriver into this hole to keep tool in position.
Put coupler nut onto coupler bolt and screw down at least three turns.
Use coupler pull-up tool or claw hammer to seat bottom coupler into bottom coupler pocket.

7. Remove coupler nut and insert coupler top (round hole piece) into pocket being careful not to put excessive pressure that would push bottom coupler back out.

8. Use hammer or coupler pull-up tool to firmly seat top coupler into dock pocket.

9. Use 3/8" hex head wrench to tighten coupler nut. Be careful not to over-tighten coupler nut.

10.Slide coupler installation tool out through the un-coupled side of dock. You may need to tilt tool as shown to free it from bottom coupler.

This page was created by Mey 12/03/2003